User Guide
4 Port eSATA RAID5/JBOD
PCI-E 8x Controller
T E C H N O L O G I E S
(ADSA3GPX8-4E)
BIOS Jumper (J4)
Hard Drive Activity LED
Jumper Connections
Fan
eSATA Ports
BIOS Jumper (J4)
Enable BIOS (1-2) – RAID firmware is active
Disable BIOS (2-3) – Base firmware is active
By default, the BIOS jumper is set to enable BIOS (1-2) for the ADSA3GPX8-4E. This means that when
you boot into a system, after POST, the RAID BIOS of the controller card with the attach devices shows
up. The RAID driver needs to be installed.
If the BIOS jumper is set to disable BIOS (2-3) when you boot into a system, after POST, the RAID BIOS
of the controller card does NOT show up. The BASE driver needs to be installed.
v4.1.11
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
|
Nespresso Coffeemaker User Manual
Melissa 645 089 User Manual
Maxtor OneTouch II E01H500 User Manual
Marantz SA8003 User Manual
Kalorik Team International Group Coffeemaker CM 38933 User Manual
JVC KD S895 User Manual
IBM DTLA 305040 User Manual
Hitachi Travelstar HTS545025A7E381 User Manual
Fujitsu MAY2036RC User Manual
Ego Technology 4000 Plus User Manual