P R E L I M I N A R Y T E C H N I C A L D A T A S H E E T
RSL-6
RSL-6
INTRODUCTION
Remote Controlled Speaker Selection System
SPECIFICATIONS
Individual ON/OFF but-
The RSL-6 is a Infrared Remote
Controlled Speaker Selection
System for up to six pairs of
speakers. The supplied remote
control enables you to select
any pair, any combination
tons for each pair
of speakers.
IR Range
30 feet @ 30 degrees
off-axis
ALL OFF button
turns your entire
system off.
Audio Power
Handling
of pairs, or all six pairs of
Hand-held IR
remote gives you
convenient control.
speakers at once. You don’t have
to worry about overloading your
amplifier. The RSL-6 has a programmable
microprocessor that constantly monitors
which speakers are playing and selects exact-
ly the right amount of protection for your
amplifier.
250 watts/channel con-
tinuous music power
Frequency Response
20Hz to 20kHz +0dB,
-0dB (flat)
Mounting
ALL-ON button enables you to
turn on all or some of your speakers
depending upon the rear panel DIP
switch settings.
Table-top component
Wiring Requirements
Individual runs of
2-conductor speaker
wire. Connectors can
accommodate 14-22
gauge
Red POWER LED turns green
momentarily confirming that an
IR command was detected.
Red LED indicators Recessed areas for
ALL-ON button enables you to turn on
all or some of your speakers depending
upon the rear panel DIP switch settings.
for each pair of
speakers.
custom room labels.
RSL-6 REMOTE HIGH DEFINITION SPEAKER SELECTION SYSTEM
Overall Dimensions
ALL ON
ALL OFF
17" Wide x 2" High x
8-3/4" Deep
1
2
3
4
5
6
Weight 6-1/2 LBS
Infrared Sensor
Attractive low-
profile design.
Simple push-button ON/OFF
operation for each pair.
ALL OFF button turns your
entire system off.
FEATURES AND BENEFITS
Computerized Protection
Room LED’s and Labels.
Remote Control
Proudly Made in USA
The brain of the RSL-6 is an eight Red LED’s indicate when a pair
bit modified Harvard Architec- of speakers is on. 72 pre-print-
ture Microcontroller. The micro- ed room labels are included for
controller is programmed to easy identification.
The slim, elegant remote con-
trol (included) allows you to
completely control which
speakers are playing. Each pair
of speakers has its own ON/OFF
button. In addition, a program-
mable ALL O N button (you
select which rooms will turn
on) and an ALL O FF button
allow you to conveniently stop
or start your music with one
touch!
The RSL-6 is made in Miami,
Florida and comes with a limit-
ed two year parts and labor
warranty.
remember the impedance of
each of your speaker pairs and X-10® Powerline Control
your amplifier’s ideal load. It
constantly monitors how many Using optional X-10 wireless
speaker pairs are playing (and remotes and controllers you
which pairs), calculates the can control the RSL-6 through
exact amount of impedance the existing 120v AC electrical
protection necessary, and pro- wires in your home. Optional
vides the proper amount of pro- Niles TW-523 interface module
B L
E
N
N
D
D
I
N
G
H
I
G
T
H
E
F I
D
E
L
I
T
Y
tection for your amplifier.
is required.
A
A R
C
H
I
C
T
U
R
E ®
CONTINUED OTHER SIDE
|